How do I remove the outlines around Genesis figures when using Poser 11 and DSON?
willshetterly last edited by
My Genesis figures have a small black outline around them, as if I was using Geometric Edge Lines with a very low setting. It's especially noticeable on the plane for the eyelashes. I looked in the Material Room and tried a few settings, but I may have missed something obvious. Any suggestions?
willdial last edited by
Unfortunately, DSON uses the outline for it's own subdivision. The outline doesn't show up on the final render.
If you need the outline hidden, you can set the figure's Mesh Resolution to "-1"
willshetterly last edited by willshetterly
@willdial Thank you! I like to render in Comic Book Preview, so your solution will be very handy, I suspect.